How to Use a 17/64” Cobalt Drill Bit on Metal: Clean Cuts Made Simple
The 17/64” drill bit (6.75mm) is slightly under 7mm and often used for creating clearance holes or pre-drilling for large fixings. While not as common as round numbers like 1/4” or 3/8”, this bit size is important when precision and tight tolerances matter. This guide shows how to use a cobalt version of the 17/64” drill bit to cleanly drill through mild steel, stainless, and more.
Where a 17/64” Drill Bit Comes in Handy
At just under 7mm in diameter, the 17/64” drill bit is useful for:
Clearance holes for bolts or threaded inserts
Fabrication work where 1/4” is too tight
Stainless steel enclosures or mounting plates
Farm machinery or automotive repair
It’s ideal when your job requires slightly more space than a 1/4” hole, but not quite 9/32”.
Why Choose a 17/64” Cobalt Bit Over Standard HSS?
Cobalt drill bits provide greater hardness and heat resistance, making them ideal for drilling into dense, hard materials. For a less-common size like 17/64”, choosing cobalt ensures you won’t be replacing the bit after only a few uses.
Cobalt Benefits at This Size:
Handles stainless and hardened steel
Stays sharp longer than regular HSS
Doesn’t lose performance as quickly under heat
Maintains its cutting edge throughout the full bit length
🧪 TTP HARD cobalt bits are SGS-tested to Rockwell 66—built to cut hard metals again and again.
Drill Speeds for 17/64” Bits on Metal
Using the right RPM helps extend the life of your bit and gives you a smoother cut.
Smart Drilling Tips for 17/64” Holes
✅ Use Lubricant – Reduce heat and extend bit life with cutting paste.
✅ Drill a Pilot Hole – A 1/8” or 3/16” starter hole helps keep things accurate.
✅ Work Slowly on Stainless – Let the cobalt edge do the work—don’t force it.
✅ Clear the Chips – Back out every few seconds to remove swarf.
✅ Clamp Everything Securely – Prevent chatter and wandering during the cut.
A quality 17/64” cobalt drill bit is essential when you need a precision hole in stainless or mild steel.
17/64” Drill Bit FAQ
What’s the metric equivalent of 17/64”?
17/64” is approximately 6.75mm.
Is cobalt the best material for drilling metal?
Yes—especially for stainless or hard steel. Cobalt resists heat and stays sharper longer than standard bits.
Can I use this size in a cordless drill?
Yes—just use a slow speed and apply minimal pressure to maintain control.
Should I drill a pilot hole first?
It’s a good idea, especially in hard or thick material. It helps accuracy and reduces stress on the bit.
The 17/64” cobalt drill bit offers a rare combination of precision and toughness. If you’re working in metal and need just a bit more space than 1/4”, this size is perfect. Combine a cobalt bit with correct speed, paste, and prep—and you’ll drill smoother, faster, and with less wear.






